Cable lines EN: различия между версиями

Материал из WiKi - UserSide
Нет описания правки
Нет описания правки
Строка 70: Строка 70:
<span id="anchor_317_7">Starting from version 3.17 it is possible to add cable routes and cable ducts directly from the map.</span>
<span id="anchor_317_7">Starting from version 3.17 it is possible to add cable routes and cable ducts directly from the map.</span>


[[Файл:|thumb|800px|center]]
[[Файл:2023-06-07_19-25-13.png|thumb|800px|center]]


When adding a route, you can immediately specify the creation of the desired cable ducts. The form for adding a route provides three types of cable ducts to be created in the route at the same time.
When adding a route, you can immediately specify the creation of the desired cable ducts. The form for adding a route provides three types of cable ducts to be created in the route at the same time.


[[Файл:2023-06-07_17-26.png|thumb|800px|center]]
[[Файл:2023-06-07_17-26.png|thumb|800px|center]]

Версия от 16:26, 7 июня 2023

en | ru

ATTENTION: This section is relevant for ERP "UserSide" versions 3.14 and above. For versions below 3.13 - use a separate FOCAL or Communication Lines page.

Also see:

The general cable management functionality allows different types of cable infrastructure to be documented. These can be fibre optic, copper, electrical cables, low voltage networks, SCA, etc.

Line information is displayed in line card.

Starting from version 3.17, it is possible to extend cable lines not only to a communication facility or building, but also to a specific user. Previously, it was only possible to reach a communication installation or a building.

In this case, the communication line on the map will no longer be drawn to the centre of the building, but to the coordinates of the user (if specified by the user).

In group actions on cable lines, it is possible to specify an individual colour on the map by checking the required values (from version 3.17).


Starting from version 3.18:

For a cable line it is possible to build a list of dependent users on that line.

Cable line card and cable lists display the cable fibre type.

In the add cable line window, added a link to create a new cable brand.

When changing the fibre colour of a particular cable line, an option has been added to copy the colours from the fibres above.

Routes of cable lines

For those line types that support this, it is possible to combine them into routes. Route is a set of logically combined lines.

For the route, you can view the layout of the construction lengths and the mounted fiber optical junction boxes of the route.

Starting from version 3.17 it is possible to add cable routes and cable ducts directly from the map.

When adding a route, you can immediately specify the creation of the desired cable ducts. The form for adding a route provides three types of cable ducts to be created in the route at the same time.