Cable lines EN: различия между версиями
Нет описания правки |
Нет описания правки |
||
| Строка 25: | Строка 25: | ||
[[Файл:2023-06-02_16-41.png|thumb|800px|center]] | [[Файл:2023-06-02_16-41.png|thumb|800px|center]] | ||
[[Файл:|thumb|800px|center]] | In this case, the communication line on the map will no longer be drawn to the centre of the building, but to the coordinates of the user (if specified by the user). | ||
[[Файл:2022-01-24 14-51.png|thumb|800px|center]] | |||
[[Файл:|thumb|800px|center]] | [[Файл:|thumb|800px|center]] | ||
Версия от 13:51, 2 июня 2023
ATTENTION: This section is relevant for ERP "UserSide" versions 3.14 and above. For versions below 3.13 - use a separate FOCAL or Communication Lines page.
Also see:
- Line card
- Line routes on a map
- Calculation of the connection route
- Adding a line from the coverage map
- Line export to KML "(Google Earth)"
- Settings - Cable Lines
The general cable management functionality allows different types of cable infrastructure to be documented. These can be fibre optic, copper, electrical cables, low voltage networks, SCA, etc.
Line information is displayed in line card.
Starting from version 3.17, it is possible to extend cable lines not only to a communication facility or building, but also to a specific user. Previously, it was only possible to reach a communication installation or a building.
In this case, the communication line on the map will no longer be drawn to the centre of the building, but to the coordinates of the user (if specified by the user).
[[Файл:|thumb|800px|center]]
[[Файл:|thumb|800px|center]]
[[Файл:|thumb|800px|center]]
[[Файл:|thumb|800px|center]]
[[Файл:|thumb|800px|center]]
[[Файл:|thumb|800px|center]]