Auto assignment of customers to ports: различия между версиями
Нет описания правки |
Нет описания правки |
||
| Строка 5: | Строка 5: | ||
[[File:2023-12-11_19-49.png|frame|1000px|center]] | [[File:2023-12-11_19-49.png|frame|1000px|center]] | ||
In the process, the ERP "UserSide" obtains information about the MAC addresses on the equipment ports. If these MAC addresses are known and belong to | In the process, the ERP "UserSide" obtains information about the MAC addresses on the equipment ports. If these MAC addresses are known and belong to customers - then it performs [[Object Commutation|commutation]] of the found customers with the ports. | ||
The following logic is followed: | The following logic is followed: | ||
| Строка 11: | Строка 11: | ||
* autoswitching is enabled only if there is no MAC address or 1 MAC address on a port. | * autoswitching is enabled only if there is no MAC address or 1 MAC address on a port. | ||
* if there is more than 1 MAC address on a port, autoswitching is disabled. | * if there is more than 1 MAC address on a port, autoswitching is disabled. | ||
* if there is 1 MAC-address on the port and it belongs to a | * if there is 1 MAC-address on the port and it belongs to a customer, the customer will switch to the port and autoswitching on this port will be switched off. | ||
* if there is a MAC address on port 1 and its owner is unknown, autoswitching continues to work, waiting for the owner of the MAC address to be found out. | * if there is a MAC address on port 1 and its owner is unknown, autoswitching continues to work, waiting for the owner of the MAC address to be found out. | ||
Autoswitching is executed when the scheduler job "2. [[Scheduler - Autosnap of the | Autoswitching is executed when the scheduler job "2. [[Scheduler - Autosnap of the customers to the ports]]" | ||
Версия от 18:24, 29 марта 2024
For switches ports, you can enable so-called "Autoswitching of ports".
In the process, the ERP "UserSide" obtains information about the MAC addresses on the equipment ports. If these MAC addresses are known and belong to customers - then it performs commutation of the found customers with the ports.
The following logic is followed:
- when a managed switch is added, autoswitching is enabled for all ports
- autoswitching is enabled only if there is no MAC address or 1 MAC address on a port.
- if there is more than 1 MAC address on a port, autoswitching is disabled.
- if there is 1 MAC-address on the port and it belongs to a customer, the customer will switch to the port and autoswitching on this port will be switched off.
- if there is a MAC address on port 1 and its owner is unknown, autoswitching continues to work, waiting for the owner of the MAC address to be found out.
Autoswitching is executed when the scheduler job "2. Scheduler - Autosnap of the customers to the ports"