Auto assignment of customers to ports: различия между версиями

Материал из WiKi - UserSide
м (N.Skrypnik переименовал страницу Auto assignment of users to ports в Auto assignment of customers to ports: Renaming)
Нет описания правки
Строка 1: Строка 1:
[[Auto_assignment_of_users_to_ports|en]] | [[Автопривязка_абонентов_к_портам|ru]]
[[Auto_assignment_of_customers_to_ports|en]] | [[Автопривязка_абонентов_к_портам|ru]]


For [[Switches|switches]] ports, you can enable so-called "Autoswitching of ports".
For [[Switches|switches]] ports, you can enable so-called "Autoswitching of ports".

Версия от 18:01, 22 марта 2024

en | ru

For switches ports, you can enable so-called "Autoswitching of ports".

In the process, the ERP "UserSide" obtains information about the MAC addresses on the equipment ports. If these MAC addresses are known and belong to users - then it performs commutation of the found users with the ports.

The following logic is followed:

  • when a managed switch is added, autoswitching is enabled for all ports
  • autoswitching is enabled only if there is no MAC address or 1 MAC address on a port.
  • if there is more than 1 MAC address on a port, autoswitching is disabled.
  • if there is 1 MAC-address on the port and it belongs to a user, the user will switch to the port and autoswitching on this port will be switched off.
  • if there is a MAC address on port 1 and its owner is unknown, autoswitching continues to work, waiting for the owner of the MAC address to be found out.

Autoswitching is executed when the scheduler job "2. Scheduler - Autosnap of the users to the ports"